
HT3



HT3 Programming Manual and Videos are below
The HT3 is an excellent full option thermostat that is easy to program and easy to install. The HT3 can be used as a new install or as a replacement for an existing thermostat.
The HT3 comes in three parts. The thermostat, the mounting block, and the electrical block. The thermostat attached to the electrical block via an electrical ribbon. The electrical block acts like a circuit breaker for an electrical surge. The electrical block is the part likely to be affected by an electrical surge and can be replaced without having to buy another thermostat.
The HT3 comes in four different options:
-
Vertical White
-
Vertical Black
-
Horizontal White
-
Horizontal Black
All Heatwell thermostats come with a 2-year warranty. All thermostats are tested in NZ, and come pre-set.
Products Specs Modes: Manual Program Manual override Settings: (F) Floor probe (A) Air Sensor (AF) Air Sensor + Floor Probe Possible schedules: 7 day 5 + 2 day Single day Programmable: 2 time periods per day Time: 24-hour clock 12-hour clock Lockable Standby battery Touch screen Dimensions: 12cm x 8cm x 1.8cm Weight: 0.3kg Volts - electrical block: 230-240 VAC Volts – thermostat: 5V Max Capacity: 16 Amps Maximum temp: 40 degrees Celsius Minimum temp: 5 degrees Celsius Frost Protection: 3 degrees Celsius Floor probe options (kohms): 3 / 10 (default) / 15 / 25 / 50 / 100
HT3 Manual - Downloadable PDF
HT3 Programming Videos
Programming the HT3
Please watch the following video to understand how to operate the HT3HT3 Setup - Parameter Settings
Please watch the following video when setting up the HT3, or if you need to reset some parameters due to an error.
Parameter settings should not be adjusted during day to day operation
Problem Solving
Please watch the following video when you are having issues with the operation of the HT3. Specifically if the FT (Floor Temperature) or RT (Room Temperature) seems too high, or the ET error is showing